Service maintenance of pneumatic tyres for mobile underground mining machines

DOI: https://doi.org/10.30686/1609-9192-2024-2-65-69

Читать на русскоя языкеV.A. Rakitin1, Yu.V. Malakhov2, 3 , D.A. Pashkov3
1 ERT-GROUP LLC, Ekaterinburg, Russian Federation
2 Institute of Comprehensive Exploitation of Mineral Resources of the Russian Academy of Sciences, Moscow, Russian Federation
3 T.F. Gorbachev Kuzbass State Technical University, Kemerovo, Russian Federation

Russian Mining Industry №2 / 2024 стр. 65-69

Abstract: The article presents the issue of short life of pneumatic tyres for mobile underground mining machines. It is noted that the correct choice of pneumatic tyres will increase the tyre life, but for a greater increase it is necessary to control the entire life cycle of the tyre, i.e. to carry out its service. The life cycle stages to be taken into account during tyre maintenance are presented. Control at each stage will minimise damage to the pneumatic tyres. The maintenance phase should include the records of tyre usage history and stock management. Analysis of the records will help to determine the reasons for tyre rejection and the wear conditions, the tyre condition before and after repair, and before and after retreading. Service maintenance of pneumatic tyres will allow planning the approximate level of stock, replacement periods and effective stock management. The article justifies the relevance of holding joint meetings of service specialists, tyre designers, and the company’s. In conclusion, it is noted that the issue of creating a national standard of service maintenance of pneumatic tyres for mobile underground mining machines is relevant.

Keywords: service, pneumatic tyres, mobile machines, mining machines, road quality, operating conditions

For citation: Rakitin V.A., Malakhov Yu.V., Pashkov D.A. Service maintenance of pneumatic tyres for mobile underground mining machines. Russian Mining Industry. 2024;(2):65–69. (In Russ.) https://doi.org/10.30686/1609-9192-2024-2-65-69


Article info

Received: 07.03.2024

Revised: 02.04.2024

Accepted: 03.04.2024


Information about the authors

Vasily A. Rakitin – General Director, ERT-Group LLC, Ekaterinburg, Russian Federation; e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

Yuri V. Malakhov – Cand. Sci. (Eng.), Senior Researcher, Institute of Comprehensive Exploitation of Mineral Resources of the Russian Academy of Sciences, Moscow, Russian Federation; Department of Open Pit Mining, T.F. Gorbachev Kuzbass State Technical University, Kemerovo, Russian Federation; e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

Dmitry A. Pashkov – Cand. Sci. (Eng.), Senior Researcher, Research Center “Digital Technologies”, T.F. Gorbachev Kuzbass State Technical University, Kemerovo, Russian Federation.


References

1. Кульпин А.Г. Исследование потока отказов крупногабаритных шин карьерных автосамосвалов. Горное оборудование и электромеханика. 2018;(5):29–35. https://doi.org/10.26730/1816-4528-2018-5-29-34 Kulpin A.G. Study of failures of off-the-road tires used on quarry dump trucks. Mining Equipment and Electromechanics. 2018;(5):29–35. (In Russ.) https://doi.org/10.26730/1816-4528-2018-5-29-34

2. Dewangan N., Gopal S., Ali F., Bansal A., Mahilang N. Use of waste tyre in concrete. International Journal for Research in Applied Science & Engineering Technology. 2023;11(6):1674–1684. https://doi.org/10.22214/ijraset.2023.53882

3. Ракитин В.А., Малахов Ю.В., Пашков Д.А. Проблемы повышения эффективности эксплуатации пневматических шин на самоходных машинах для подземных горных работ. Горная промышленность. 2023;(5):62–65. https://doi.org/10.30686/1609-9192-2023-5-62-65 Rakitin V.A., Malakhov Yu.V., Pashkov D.A. Challenges of increasing the efficiency of pneumatic tire operation on mobile underground mining equipment. Russian Mining Industry. 2023;(5):62–65. (In Russ.) https://doi.org/10.30686/1609-9192-2023-5-62-65

4. Малахов Ю.В., Ракитин В.А., Пашков Д.А. Разработка стандартизированного подхода по выбору пневматических шин на самоходные машины для подземных горных работ. Горная промышленность. 2024;(1):52–58. https://doi. org/10.30686/1609-9192-2024-1-52-58 Malakhov Yu.V., Rakitin V.A., Pashkov D.A. Development of a standardized approach to selection of pneumatic tires for self-propelled machines for underground mining operations. Russian Mining Industry. 2024;(1):52–58. (In Russ.) https://doi.org/10.30686/1609-9192-2024-1-52-58

5. Muminov R.O., Kuziev D.A., Zotov V.V., Sazankova E.S. Performability of electro-hydro-mechanical rotary head of drill rig in open pit mining: A case-study. Eurasian Mining. 2022;(1):76–80. https://doi.org/10.17580/em.2022.01.16

6. Gerike B., Drozdenko Yu., Kuzin E., Ananyin I., Kuziev D. Formation of comprehensive service system of belt conveyor gearboxes. E3S Web of Conferences. 2018;41:03011. https://doi.org/10.1051/E3SCONF/20184103011

7. Liu Y., Chen H., Wu S., Gao J., Li Y., An Z. et al. Impact of vehicle type, tyre feature and driving behaviour on tyre wear under realworld driving conditions. Science of The Total Environment. 2022;842:156950. https://doi.org/10.1016/j.scitotenv.2022.156950

8. Becker C., Els S. Agricultural tyre stiffness change as a function of tyre wear. Journal of Terramechanics. 2022;102:1–15. https://doi.org/10.1016/j.jterra.2022.04.001

9. Горюнов С.В., Хорешок А.А. Разработка методики оценки ресурса крупногабаритных шин карьерных автосамосвалов. Горное оборудование и электромеханика. 2021;(2):3–10. https://doi.org/10.26730/1816-4528-2021-2-3-10 Goryunov S.V., Khoreshok A.A. Development of a methodology for assessing the resource of large-sized tires of quarry dump trucks. Mining Equipment and Electromechanics. 2021;(2):3–10. (In Russ.) https://doi.org/10.26730/1816-4528-2021-2-3-10

10. Mahjouri S., Shabani R., Skote M. Reducing temperature, drag load and wear during aircraft tyre spin-up. Aircraft Engineering and Aerospace Technology. 2022;94(6):906–914. https://doi.org/10.1108/AEAT-09-2021-0287

11. Shah B., Trivedi V., Waghela J., Yadav Z. Pneumatic vulcanizing machine for tyres. International Journal of Scientific Research in Engineering and Management. 2022;6(5):1–7. https://doi.org/10.55041/IJSREM12694

12. Ефимов В.И., Кротиков О.В. Оценка эффективности эксплуатации крупногабаритных шин на угольных разрезах ОАО «ХК «СДС-уголь». Известия Тульского государственного университета. Науки о Земле. 2013;(2):112–117. Efimov V.I., Krotikov O.V. Evaluation of the operational efficiency of large-sized tires on coal mines JSC HC “SBU-coal”. Izvestiya Tulskogo Gosudarstvennogo Universiteta. Nauki o Zemle. 2013;(2):112–117. (In Russ.)