Diagnostics of pipelines and shut-off and distribution valves using the analysis of excited vibrations
N.N. Sofina1, D.I. Shishlyannikov2, A.V. Nikolaev2, A.A. Rybin2, D.A. Sitnikov2
1 Research and Production Enterprise ROS, Perm, Russian Federation
2 Perm National Research Polytechnic University, Perm, Russian Federation
Russian Mining Industry №5 / 2024 p.122-128
Abstract: Mining and oil and gas enterprises use various pipeline designs and pipe fittings to transport various combustible, explosive, toxic and other hazardous media, both liquid and gaseous. To prevent emergencies leading to production downtime, harming the life and health of personnel, as well as affecting the environmental situation, modern technical means are required to detect emerging defects in a timely manner and with sufficient accuracy. The article justifies the relevance to use nondestructive testing methods in assessing the technical condition and residual life of pipelines and shut-off valves of mining and oil and gas sector enterprises. The prospects of diagnosis by the method of analysis of excited oscillations are proved. The design and algorithm of operation of the Kamerton diagnostic complex produced by the ROS Research and Production Enterprise (Perm) are described. The methodological basis of defect finding using the Kamerton multichannel analyzer are described. The main characteristics of the registered signals are listed that characterize the condition of the elements of the technical facilities based on the results of diagnostics. In terms of efficiency and timely response, the method has no analogues in comparison with traditional methods of non-destructive equipment testing, e.g. the magnetic, eddy current, ultrasonic flaw detection, ultrasonic thickness measurement, radiation, radio wave, penetrating substances control, and other methods. In some cases, for example, for the elements made of ceramics, materials of heterogeneous structure such as polymers or concrete, the proposed method is the only possible diagnostic method.
Keywords: pipelines, pipe fittings, distortion of the material homogeneity, non-destructive testing, method of analysis of excited vibrations, diagnostic complex
Acknowledgements: The research was funded by the Ministry of Science and Higher Education of the Russian Federation (Project No.FSNM-2024-0005).
For citation: Sofina N.N., Shishlyannikov D.I., Nikolaev A.V., Rybin A.A., Sitnikov D.A. Diagnostics of pipelines and shut-off and distribution valves using the analysis of excited vibrations. Russian Mining Industry. 2024;(5):122–128. (In Russ.) https://doi.org/10.30686/1609-9192-2024-5-122-128
Article info
Received: 13.07.2024
Revised: 27.08.2024
Accepted: 18.09.2024
Information about the authors
Natalia N. Sofina – Director, Research and Production Enterprise ROS, Perm, Russian Federation; е-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
Dmitriy I. Shishlyannikov – Dr. Sci. (Eng.), Professor, Associate Professor of the Department of Mining Electromechanics, Perm National Research Polytechnic University, Perm, Russian Federation; https://orcid.org/0000-0002-7395-6869 ; e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
Aleksandr V. Nikolaev – Dr. Sci. (Eng.), Associate Professor of the Department of Mining Electromechanics, Perm National Research Polytechnic University, Perm, Russian Federation; https://orcid.org/0000-0002-4601-5780 ; e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
Alexander A. Rybin – Dr. Sci. (Eng.), Professor, Associate Professor of the Department of Mining Electromechanics, Perm National Research Polytechnic University, Perm, Russian Federation; https://orcid.org/0009-0007-8315-218X ; e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
Dmitry A. Sitnikov – Laboratory assistant at the Department of Mining Electromechanics, Perm National Research Polytechnic University, Perm, Russian Federation; https://orcid.org/0009-0003-4909-7886 ; e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
References
1. Шишлянников Д.И. Основы эксплуатации и ремонта бурового и нефтегазодобывающего оборудования. Пермь: ПНИПУ; 2018. 150 с.
2. Yungmeister D.A., Lavrenko S.A., Yacheikin A.I., Urazbakhtin R.Y. Improving the shield machine cutter head for tunneling under the conditions of the Metrostroy Saint Petersburg mines. ARPN Journal of Engineering and Applied Sciences. 2020;15(11):1282‒1288. Available at: http://www.arpnjournals.org/jeas/research_papers/rp_2020/jeas_0620_8228.pdf (accessed: 28.03.2024).
3. Блинов П.А., Шаньшеров А.В., Черемшанцев Д.М., Кузнецова Н.Ю., Никишин В.В. Анализ и выбор тампонажной смеси, устойчивой к динамическим нагрузкам, с целью повышения качества герметичности крепи в затрубном пространстве. Известия Томского политехнического университета. Инжиниринг георесурсов. 2022;333(11):115–123. https://doi.org/10.18799/24131830/2022/11/3726 Blinov P.A., Shansherov A.V., Cheremshantsev D.M., Kuznetsova N.Yu., Nikishin V.V. Analysis and selection of a grouting mixture, resistant to dynamic loads, in order to improve the support tightness quality in the annulus. Bulletinof the Tomsk Polytechnic University. Geo Assets Engineering. 2022;333(11):115–123. (In Russ.) https://doi.org/10.18799/24131830/2022/11/3726
4. Бернс В.А., Долгополов А.В., Маринин Д.А. Модальный анализ конструкций по результатам испытаний их составных частей. Доклады Академии наук высшей школы Российской Федерации. 2014;(1):34–42. Режим доступа: https://journals.nstu.ru/doklady/catalogue/contents/view_article?id=2324 (дата обращения: 28.03.2024). Berns V.A., Dolgopolov A.V., Marinin D.A. Modal analysis of structures based on the test of their components. Proceedings of the Russian Higher School Academy of Sciences. 2014;(1):34–42. (In Russ.). Available at: https://journals.nstu.ru/doklady/catalogue/contents/view_article?id=2324 (accessed: 28.03.2024).
5. Segopolo P.R. Optimization of shuttle car utilization at an underground coal mineю The Journal of the Southern African Institute of Mining and Metallurgy. 2015;115(4):285–296. https://doi.org/10.17159/2411-9717/2015/v115n4a4
6. Brodny J., Tutak M. Application of elements of TPM strategy for operation analysis of mining machineю IOP conf. series: Earth and Environmental Science. 2015;95(4):042019. https://doi.org/10.1088/1755-1315/95/4/042019
7. Ботян Е.Ю., Лавренко С.А., Пушкарев А.Е. Методика уточненного расчета межремонтного периода элементов подвески карьерных автосамосвалов посредством учета горнотехнических условий их эксплуатации. Горная промышленность. 2024;(1):71–76. https://doi.org/10.30686/1609-9192-2024-1-71-76 Botyan E.Y., Lavrenko S.A., Pushkarev A.E. Methodology for refined calculation of mean time to repair of mining dump truck suspension elements with account of mining and technical conditions of their operation. Russian Mining Industry. 2024;(1): 71–76. (In Russ.) https://doi.org/10.30686/1609-9192-2024-1-71-76
8. Софьина Н.Н., Островский В.Г., Воробель С.В., Романов В.А., Зверев В.Ю. Диагностирование нефтепромыслового и горного оборудования методом анализа возбужденных резонансных колебаний. Известия высших учебных заведений. Горный журнал. 2019;(3):107–114. Sofina N.N., Ostrovskii V.G., Vorobel S.V., Romanov V.A., Zverev V.Iu. Diagnosis of oilfield and mining equipment by analyzing excited resonant oscillations. Izvestiya vysshikh uchebnykh zavedenii. Gornyi zhurnal. 2019;(3):107–114. (In Russ.)
9. Липницкий Н.А., Огородников Р.Г., Устинова Я.В. Создание имитационной модели работы подземных усреднительных складов руды рудника сложноструктурных соляных месторождений. Горный информационно-аналитический бюллетень. 2023;(1):142–158. https://doi.org/10.25018/0236_1493_2023_1_0_142 Lipnitsky N.A., Ogorodnikov R.G., Ustinova Ya.V. Simulation modeling of underground blending warehouse operation at structurally complex salt deposits. Mining Informational and Analytical Bulletin. 2023;(1):142–158. (In Russ.) https://doi.org/10.25018/0236_1493_2023_1_0_142
10. Kuvshinkin S., Ivanova P. Impact analysis of bucket capacity and boom length of mining excavators on hoisting mechanism life. E3S Web of Conferences. 2021;326:00032. https://doi.org/10.1051/e3sconf/202132600032
11. Iakupov D., Motyakov N., Ivanova P., Ivanov S. Working parts of means of minerals excavation. AIP Conference Proceedings. 2022;2456(1):030012. https://doi.org/10.1063/5.0074835
12. Имансакипов Р.М., Завьялов А.П. Особенности применения метода возбужденных резонансных колебаний для оценки технического состояния оборудования НПЗ. Химическая техника. 2016;(6):10. Режим доступа: https://chemtech.ru/osobennosti-primenenija-metoda-vozbuzhdennyh-rezonansnyh-kolebanij-dlja-ocenki-tehnicheskogo-sostojanijaoborudovanija-npz/ (дата обращения: 28.03.2024). Imansakipov R.M., Zavyalov A.P. Features of the application of the method of excited resonant vibrations to assess the technical condition of refinery equipment. Chemical Engineering. 2016;(6):10. (In Russ.) Available at: https://chemtech.ru/osobennosti-primenenija-metoda-vozbuzhdennyh-rezonansnyh-kolebanij-dlja-ocenki-tehnicheskogo-sostojanijaoborudovanija-npz/ (accessed: 28.03.2024).
13. Petrakov D.G., Loseva A.V., Jafarpour H.A., Penkov G.M. Experimental evaluation of effective chemical composition on reservoir quality of bottomhole zone of low permeability terrigenous reservoirs. International Journal of Engineering. 2024;37(8):1547–1555. https://doi.org/10.5829/IJE.2024.37.08B.08
14. Zhukovskiy Yu., Buldysko A., Revin I. Induction motor bearing fault diagnosis based on singular value decomposition of the stator current. Energies. 2023;16(8):3303. https://doi.org/10.3390/en16083303
15. Zhukovskiy Yu., Koshenkova A., Vorobeva V., Rasputin D., Pozdnyakov R. Assessment of the impact of technological development and scenario forecasting of the sustainable development of the fuel and energy complex. Energies. 2023;16(7):3185. https://doi.org/10.3390/en16073185
